This guy made a fan adapter for the Original Original Xbox (1.0): Xbox 1.0 GPU 40mm Fan adapter.
Xbox 1.0 GPU 40mm Fan adapter
Reply
Monthly Archives: February 2023
Using LEDs as mains indicator lights on 120V and 230V
Watched a video about how to implement a mains indicator: Using LEDs as mains indicator lights on 120V and 230V (live demos).
SMART error on disk used with ZFS and mdadm
So I joined superuser.com to ask a question: SMART error on disk used with ZFS and mdadm.
Power-on indicator
I’m embarrassed to report that I don’t know how to solve the problem of providing a power-on indicator on my Xbox test power supply, so I asked.
DC-580 buck-boost power supply with CH340N IC
Universal Magnetic Car Phone Holder
I found these cool magnets: Universal Magnetic Car Phone Holder Dashboard Hands-Free Mobile GPS Mount Stand. I didn’t buy any, but I might!
And speaking of magnetic material I should get, these look cool too: A4 Magnet Sheets Black Magnetic Mats for Refrigerator Photo and Picture Cutting Die Craft Magnets Magnetic on One Side 0.5mm.
The NanoVNA, a beginners guide to the Vector Network Analyzer
Found this great video: The NanoVNA, a beginners guide to the Vector Network Analyzer. Good links in the description. My mate Raz says to get NanoVNAs from either here or here.
Dielectric loss
Some light reading: Dielectric loss.
Progress
Today is the first day I have used my signal generator, my scope, and a breadboarded circuit, at the same time. Used my multi-meter with its new cables too!
Thanks to my friend Raz for his help. <3
Frequency response
So I pumped a 1 kHz square wave into my DTL OR gate and observed the behaviour with my scope!
The square wave is in yellow, and the blue is the output signal.
You can see the output doesn’t drop back to zero quite as fast as the input.
You can see on the multi-meter to the right that the current draw is about 5.83 mA. That’s consistent with my earlier measurements given a duty cycle of 50%.
And you can see in the following photo that the frequency response of the circuit is rubbish. If you go much above about 10 kHz the output just stays “on”.
